Yamaha G2 Golf Buggy Cart Governor Adjustment For More Speed Youtube The g2 golf buggy i'm driving has the governor 10mm nut wound all the way up. This video shows you how to adjust the governor to get more top speed out of your yamaha drive 2 quietech efi golf cart. this is an easy adjustment that anyo.
Yamaha G29 Drive Golf Cart Governor Adjustment More Speed Re: 1990 yamaha g2 slow governor adjustment question. first pic w red box is correct one to adjust. just wrap a ziptie around the whole thing and pull it tight to simulate tightening the locknut. this should get you about 18 19 mph max speed. do not adjust the cable in the other pic unless something else comes up to indicate it needs. This video goes over how to turn up the governor and properly adjust the throttle cables to get maximum speed from your 2007 2016 yamaha drive g29 gas golf c. Get under the rear bumper when the cart is cool, as the muffler is up there. use a 1 4" drive ratchet with a 10mm deep socket on it. find the lever on top of the trans the nut is at the end of it. tighten. you can tighten it all the way should not hurt anything, never seen one the rpm would get into any danger zone with the governor still on it. Yamaha g2 governor adjustment. the following methods show you how to adjust the governor on your yamaha g2 golf cart. method 1. locate the lever present above the transaxle. this lever houses a 10mm nut. tighten the nut or move it inwards as much as you want based on the desired speed using a 1 4″ drive ratchet with a 10mm deep socket.
How To Adjust Speed On A Yamaha Golf Cart At Tara Carmouche Blog Get under the rear bumper when the cart is cool, as the muffler is up there. use a 1 4" drive ratchet with a 10mm deep socket on it. find the lever on top of the trans the nut is at the end of it. tighten. you can tighten it all the way should not hurt anything, never seen one the rpm would get into any danger zone with the governor still on it. Yamaha g2 governor adjustment. the following methods show you how to adjust the governor on your yamaha g2 golf cart. method 1. locate the lever present above the transaxle. this lever houses a 10mm nut. tighten the nut or move it inwards as much as you want based on the desired speed using a 1 4″ drive ratchet with a 10mm deep socket. Join date: dec 2009. location: aiken, sc. posts: 14,081. re: 2021 drive 2 efi governor adjustment. you can try tightening the governor but speed might be limited by the efi system. tighten the nut with the 1 arrow. attached images. b5dd1034 b7ad 4299 ac02 c8c28359ed50 (178.9 kb, 0 views) 07 26 2020, 04:01 pm. Step 1: remove the rear inspection panel. you'll find spring accelerated governor below this panel. step 2: use a 10mm wrench and tighten the nut by moving it in to expose the threaded road a little more. it's advisable to wear a glove while doing this. step 3: take a test drive to see the result.
Comments are closed.