Omc Cobra Upper Unit Assembly Vlog 2 Youtube

Omc Cobra Upper Unit Assembly Vlog 2 Youtube She said fix it!. First video assembling the upper unit. seal kit: offshoremarineparts 311 32 603.

Omc Cobra Upper Unit Assembly Vlog 1 Youtube For more on the shift rod height check out this video: watch?v=3ujpucfoqka. Place the 7 16in. flat washer on the largest bolt c and install it, then screw in the remaining bolt d under the trim tab. tighten both to a torque 22 24 ft. lbs. 0317201 omc fl *gskt seal 16oz. be sure nylon plug is at base of splines inside lower driveshaft. apply gearcase oil to the splines at both ends of the intermediate driveshaft, and. Hold one locknut with a 5 8 in. box end wrench. tighten both locknuts until locknuts and washers bottom out on shoulders of pivot rod. tighten to a torque of 32 34 ft. ibs. (43 46 n'm). remove lifting eye bolt from upper housing. install oil level indicator plug using a new seal, and tighten to a torque of 48 72 in. ibs. (5 8 n.m). 1 air or low no oil in reservoir. fill reservoir and cycle trim tilt unit. 2 air in hydraulic system. cycle unit through entire range three to five times. fill reservoir. 3 manual release valve loose or leaking. tighten to a torque of 45 55 in lbs. remove and check the condition of the plastic o rings and seats.

Omc Cobra Upper Unit Assembly Vlog 3 Youtube Hold one locknut with a 5 8 in. box end wrench. tighten both locknuts until locknuts and washers bottom out on shoulders of pivot rod. tighten to a torque of 32 34 ft. ibs. (43 46 n'm). remove lifting eye bolt from upper housing. install oil level indicator plug using a new seal, and tighten to a torque of 48 72 in. ibs. (5 8 n.m). 1 air or low no oil in reservoir. fill reservoir and cycle trim tilt unit. 2 air in hydraulic system. cycle unit through entire range three to five times. fill reservoir. 3 manual release valve loose or leaking. tighten to a torque of 45 55 in lbs. remove and check the condition of the plastic o rings and seats. Remove screw d under the trim tab, then remove screw e. do not unscrew the anode screw f. [6] 5. take out the four bolts along the underside of the upper gear housing. [7] 6. the upper gear housing is now held in place only by o rings. firmly hold the housing as shown and pull upward forcefully. rotating the housing side to side while pulling. Omc cobra upper unit 21:16 #986381. $ 2,295.00. weight. 50 lbs. brand. omc. our remanufactured units won’t leave you stranded. get back out there today! price= $2,295 less $300 refundable core*= $1,995 final cost.