How To Replace A Thermostat On A 1996 4 0l Ohv V6 Fordо Take off the latch for the filter, unplug the 2 plugs in the intake, and pull the vacuum line out. now, unscrew the hose clamp with the flathead screwdriver, and remove intake. now there is that throttle cable cover there. that needs to be removed. take you 8mm socket, and remove the 2 bolts holding that on. Take off the latch for the filter, unplug the 2 plugs in the intake, and pull the vacuum line out. now, unscrew the hose clamp with the flathead screwdriver, and remove intake. now there is that throttle cable cover there. that needs to be removed. take you 8mm socket, and remove the 2 bolts holding that on.
How To Replace A Thermostat On A 1996 4 0l Ohv V6 Fordо I'm going to check the exact temperature using my scan tool today, but there seem to be a ton of different thermostat temps listed as "correct:" haynes manual: 192 199 f. autozone: 198 f. rockauto: 195 f (oe temp) rockauto: 198 f (oem recommended temp) fordparts : 197 f. a trump whose character is marred by every act which may define a. Sorry to revive this old thread but we just bought 96' ranger with this motor and it appears to have a leak. in the pics where it shows the thermostat in the block housing it appears to be leaking from below and behind that section. my fear is that it is a cracked manifold and its going to be difficult to replace. In this video i will be showing you how to remove and install the thermostat housing that comes with the thermostat for your ford explorer with a 4.0l. how t. On 3.0 engines, turn the thermostat clockwise into the housing until the thermostat bridge is perpendicular (at a right angle to) to the mounting holes. on 4.0 engines, make sure the air release valve is in the up position. 11) install the housing cover and bolts. torque the bolts to 15 20 ft lbs. 12) reattach the hose(s) to the thermostat.
Comments are closed.