How To Remove The Upper Intake Manifold On A 98 Ford Exploer Youtube Removing my upper intake manifold to access other componts 98 fordexploer v6. In this two part video series, i will show you how i replaced the upper intake and lower intake gaskets of my 1999 ford explorer 4.0l sohc.ford explorer 4.0l.
How To Replace The Upper Intake Manifold Gaskets On A 98 Ford Explo I heard some air leaking from around the upper intake manifold butcould not pin point the problem after fixing this issue the leak stoped98 ford exploer v6. Use a flat blade screwdriver to gently pry the cables (socket) off of the throttle body (ball). remove the cruise control cable from the upper intake (blue circle) and then from the throttle cable. to remove it from the throttle cable, pry it up and then off of the pin on the end of the throttle cable (red circle). Step 3. label all electrical wiring and vacuum lines attached to the upper intake manifold with masking tape and a marker. remove the accelerator cable's brackets but leave the cable in the brackets. set the brackets aside. disconnect the egr spacer or the throttle body coolant hoses, depending on which your vehicle is equipped. 1998 ford explorer ohv upper and lower intake gaskets. hi all, i am needing to replace the upper and lower intake manifold gaskets on my 98 ford explorer and have a question related to the following part: i bought the following gasket set: intake manifold gasket set by felpro (part#ms 98006 t) gaskets. does anyone know were the the gasket.
Comments are closed.