How To Remove And Install An Omc Cobra Outdrive And Change The Lower I will show you how to remove and replace an omc cobra outdrive and change the gear lube properly. Part 2 of repair video for instructions of how to remove the lower unit from an omc cobra. please visit our website at sterndrive.info for parts.
How To Remove Omc Outdrive Hold one locknut with a 5 8 in. box end wrench. tighten both locknuts until locknuts and washers bottom out on shoulders of pivot rod. tighten to a torque of 32 34 ft. ibs. (43 46 n'm). remove lifting eye bolt from upper housing. install oil level indicator plug using a new seal, and tighten to a torque of 48 72 in. ibs. (5 8 n.m). T.c. electronics marine sterndrive.info tech service representative wayne demonstrates how to remove the lower gear case from the omc cobra out. Re: 89 omc cobra outdrive replacement options. i am a little lost on whether the drive is fried and you're looking for a replacement or you're just looking to flip out the lower shift cable and fix the present drive. in any event, i can offer that i flipped the lower shift cable on my 90' 4.3 omc this spring. Remove and discard six elastic locknuts e. remove six flat washers from the pivot housing studs. pull vertical drive away from transom bracket and support driveshaft f and universal coupler g. note: the boat must be out of the water on a trailer or in a cradle for removal of the vertical drive. remove oil indicator plug from upper gear housing.
How To Install Omc Cobra Outdrive Re: 89 omc cobra outdrive replacement options. i am a little lost on whether the drive is fried and you're looking for a replacement or you're just looking to flip out the lower shift cable and fix the present drive. in any event, i can offer that i flipped the lower shift cable on my 90' 4.3 omc this spring. Remove and discard six elastic locknuts e. remove six flat washers from the pivot housing studs. pull vertical drive away from transom bracket and support driveshaft f and universal coupler g. note: the boat must be out of the water on a trailer or in a cradle for removal of the vertical drive. remove oil indicator plug from upper gear housing. Upper lower parts of out drive must be removed from the transom before beginning this job as you will need access to the shift rod located in upper gear case so that lower unit can be taken off. how to remove the lower unit on an cobra out drive is a two part video listed below. From the end of the drive shaft to the mating surface on the outdrive is approx. 16.25". the difference is 2.75". the taper on the driveshaft and the taper in the coupling spline are probably engaging a bit. this leaves the mating surfaces of the outdrive pivot housing about 2.25" apart, which is the gap i have when i try to re install the.
How To Install The Omc Cobra Outdrive Upper lower parts of out drive must be removed from the transom before beginning this job as you will need access to the shift rod located in upper gear case so that lower unit can be taken off. how to remove the lower unit on an cobra out drive is a two part video listed below. From the end of the drive shaft to the mating surface on the outdrive is approx. 16.25". the difference is 2.75". the taper on the driveshaft and the taper in the coupling spline are probably engaging a bit. this leaves the mating surfaces of the outdrive pivot housing about 2.25" apart, which is the gap i have when i try to re install the.
Comments are closed.