How To Install Wireguard Vpn On Ubuntu Server Sudo apt update. sudo apt install wireguard. now that you have wireguard installed, the next step is to generate a private and public keypair for the server. you’ll use the built in wg genkey and wg pubkey commands to create the keys, and then add the private key to wireguard’s configuration file. The procedure for installing and configuring a vpn client is the same as setting up the server. let us install the client on an ubuntu linux 20.04 lts desktop: {vivek@ubuntu 20 4 vpn client:~ }$ sudo apt install wireguard. next we need create vpn client config on ubuntu debian centos linux destkop:.
How To Install And Configure Wireguard Vpn Server On Ubuntu 22 04 Vps Step 5: install and configure wireguard client. first, you must install the wireguard package on the client machine. it is similar to setting up the wireguard server. sudo apt install wireguard. next, you’ll need to generate a public private key pair on the peer using the exact steps you used on the server. Setting up the wireguard server # we’ll start by installing wireguard on the ubuntu machine and set it up to act as a server. we’ll also configure the system to route the clients’ traffic through it. install wireguard on ubuntu 20.04 # wireguard is available from the default ubuntu repositories. to install it, run the following commands:. Server. use a command line text editor like nano to create a wireguard configuration file on the ubuntu server. wg0 will be the network interface name. sudo nano etc wireguard wg0.conf. copy the following text and paste it to your configuration file. you need to use your own server private key and client public key. Key takeaways from this introduction: each peer participating in the wireguard vpn has a private key and a public key. allowedips is used as a routing key when sending traffic, and as an acl when receiving traffic. to establish a vpn with a remote peer, you need its public key. likewise, the remote peer will need your public key.
Install Wireguard Vpn Client On Ubuntu 22 04 Itnixpro Server. use a command line text editor like nano to create a wireguard configuration file on the ubuntu server. wg0 will be the network interface name. sudo nano etc wireguard wg0.conf. copy the following text and paste it to your configuration file. you need to use your own server private key and client public key. Key takeaways from this introduction: each peer participating in the wireguard vpn has a private key and a public key. allowedips is used as a routing key when sending traffic, and as an acl when receiving traffic. to establish a vpn with a remote peer, you need its public key. likewise, the remote peer will need your public key. Wireguard server configuration. create the wireguard configuration file. sudo nano etc wireguard wg0.conf. fill it in with the following lines: # server configuration. [interface] privatekey = och7z0g ieq99kkkr1e5eo22evs5q75f es4o4oc93e= # the server private.key value. address = 10.5.5.1 24 # internal ip address of the vpn server. listenport. To start the service, run: service wg quick@wg0 start. verify that the service has started successfully: service wg quick@wg0 status. verify that the interface we created in the configuration file has started, using the ip command. ip a show wg0. the wireguard vpn server is now set up and running.
Comments are closed.