How To Fix Your Dymo Labelmanager 160 Label Jam Youtube If you bought your dymo labelmanager 160 or received it in a liquidaiton lot then this video might be for you. i was getting issues where it was saying labe. The labelmanager 160 210d 280 labellers can give a "label jam!" error, which can be caused by a motor stall or stuck cassette label tape. sometimes new tapes, or tape that has been in the machine for a long while, can stick and the motor does not have enough power to turn it.
Troubleshooting Dymo Labelmanager 160 Printer Reports Label Jam Error 2. remove the tape cassette. 3. pull 1 inch (2,5 cm) of tape out of the cassette. 4. insert the cassette again without cutting the advanced tape. 5. if there is no improvement, please try using a different tape cartridge. labelmanager, feed issue, no print, no feed, tape jam, motor stall, error, display, dhc. Cut the tape at the spot where the new adhesive begins. reinsert the cassette and try again. if the ink ribbon is not flat when the cassette was inserted then the tape is going to have a hard time printing. if this is the problem, remove the cassette and straighten out the tape so it lays flat. reinsert the cassette and try again. About your new label maker. with the dymo labelmanager 160 label maker, you can create a wide variety of high quality, self adhesive labels. you can choose to print your labels in many different font sizes and styles. the label maker uses dymo d1 label cassettes in widths of 1 4”, 3 8”, or 1 2”. labels are available in a wide range of colors. To clean your device, please follow the steps explained below. 1. turn off the label maker. 2. open the cartridge door to access the tape compartment. 3. remove the tape cassette. 4. dampen a cotton swab with a pure alcohol based solution, such as isopropyl or rubbing alcohol.
How To Fix Dymo Label Jam Youtube About your new label maker. with the dymo labelmanager 160 label maker, you can create a wide variety of high quality, self adhesive labels. you can choose to print your labels in many different font sizes and styles. the label maker uses dymo d1 label cassettes in widths of 1 4”, 3 8”, or 1 2”. labels are available in a wide range of colors. To clean your device, please follow the steps explained below. 1. turn off the label maker. 2. open the cartridge door to access the tape compartment. 3. remove the tape cassette. 4. dampen a cotton swab with a pure alcohol based solution, such as isopropyl or rubbing alcohol. Locate the split on the label backing. 2. gently pinch the label length wise, folding toward the printed side of the label. the label backing will separate. 3. carefully peel away the backing from the label. need labels ? labelcity stocks the entire range of dymo labelmanager 160 labels. if you're having an issue with your dymo labelmanager 160. 1. make sure your labelwriter printer is unplugged. 2. lift the cover to your dymo labelwriter and remove the spool holding your dymo labels. if any labels have already been fed through the printer, tear and remove. 3. the piece of the printer with the dymo name and logo is the face plate. remove that piece and set to the side.
Comments are closed.