2002 Honda Accord Timing Belt Balance Shaft Valve Cover Tune Up

2002 Honda Accord Timing Belt Balance Shaft Valve Cover Tune Up Youtube Apdty 01:01 remove spark plug wires and plugs02:17 remove valve cover03:27 loosen power steering and alternator to remove belts05:16 re. Install the timing balance belt drive pulley and the timing balance belt. <u>step 33< u> loosen the adjusting nut 2 3 1 turn to tension the timing balancer belt. <u>step 34< u> remove the bolt, screwdriver or whatever you used to hold the rear balance shaft in place and reinstall the 12mm sealing bolt into the maintenance hole at 22 lbs ft.

Replacing Timing Belt Honda Accord 2002 Install the camshaft pulley. loosen and tighten the adjusting nut to tighten the tensioner belt. install the timing balancer belt pulley and lower cover. then, tighten the bolts. install the crank pulley and bolt. rotate the crank pulley 5 6 revolutions counterclockwise, and ensure tdc marks are still in line. After replacing timing belts or timing chains, its always a good practice to manually rotate the crank shaft by hand 2 revolutions to make sure all the timing marks line up. for the rubbing sound you hear, i would do a good visual inspection of the area. however, it sounds like it may be out of time. 1) remove the cylinder head (valve) and upper timing belt covers. 2) turn the engine to align the timing marks and set cylinder no. 1 to top dead center (tdc). the white mark on the crankshaft sprocket should align with the pointer on the timing belt cover. the words up embossed on the camshaft sprocket should be aligned in the upward position. With the balance belt out of the way, loosen the just installed bolt. move the tensioner to release tension and snug the bolt. with the belt removed, check or replace the seals and water pump and install a seal retainer. installing a retainer plate holds the balance shaft seal in place. the 2.2 liter engine used in the accord had a balance.

Tips For Timing A 98 02 Honda Accord Balance Shaft 2 3l Vtec Youtube 1) remove the cylinder head (valve) and upper timing belt covers. 2) turn the engine to align the timing marks and set cylinder no. 1 to top dead center (tdc). the white mark on the crankshaft sprocket should align with the pointer on the timing belt cover. the words up embossed on the camshaft sprocket should be aligned in the upward position. With the balance belt out of the way, loosen the just installed bolt. move the tensioner to release tension and snug the bolt. with the belt removed, check or replace the seals and water pump and install a seal retainer. installing a retainer plate holds the balance shaft seal in place. the 2.2 liter engine used in the accord had a balance. With the balance belt out of the way, loosen the just installed bolt. move the tensioner to release tension and snug the bolt. with the belt removed, check or replace the seals and water pump and install a seal retainer. installing a retainer plate holds the balance shaft seal in place. the 2.2 liter engine used in the accord had a balance. 1. remove and clean the balancer belt drive pulley. 2. clean the timing belt pulleys, and the upper and lower timing cover. 3. set the crankshaft to tdc. align the dimple (a) on the tooth of the timing belt drive pulley with the pointer (b) on the oil pump. 4. clean the camshaft pulley and set it to tdc. 5. install the timing belt in a.